Purpose: This SOP provides step-by-step instructions for resetting and troubleshooting a credit card (CC) terminal to resolve network or connectivity issues, including test transaction failures.
Procedure:
-
Initiate Reset Sequence - On the terminal keypad:
- Press 9
- Press [Release]
- Press the Green (Enter) button
-
Enter Admin PIN - When prompted, Enter the admin PIN from SophicX Lock.
-
Access Network Settings - Navigate to: Network > Wi-Fi
-
Toggle Wi-Fi Off - If Wi-Fi is ON, toggle it OFF. Wait for 5–10 seconds
-
Test the Terminal - Attempt to process a test payment. If successful, the process is complete. If unsuccessful, proceed to the next step
-
Reboot the Terminal - Turn off the terminal by holding the power button or removing the battery/power cable. Wait for 10 seconds. Turn the terminal back ON
-
Re-enable Wi-Fi (If Required) - Navigate to: Network > Wi-Fi. Toggle Wi-Fi ON. Wait for the terminal to reconnect. Select the appropriate Wi-Fi network and enter the password, if prompted
-
Check for IP Address - Go to: Network > Wi-Fi. Verify the terminal has a valid IP address. If it displays 0.0.0.0 or is blank, it is not connected. Reconnect to Wi-Fi or reboot the router
-
Perform a Communication Test - From the Admin Menu: Select Comm Test or Test Connection. Confirm the terminal can reach the payment processor
-
Try a Test Payment Again - Process a small or test transaction. If successful, the issue is resolved. If not, continue to the next step
-
Check for Software Updates (Optional) - Navigate to: Settings > Software Update or Firmware Update. If updates are available, run the update. Reboot the terminal after the update completes
-
Contact Technical Support - If none of the above steps resolve the issue, contact your terminal provider's Support Line. Be ready to provide any error messages displayed, the network status (IP, Wi-Fi, etc.), and the steps already attempted.