Setting Up Your DrayTek Router

A guide for non-technical staff to physically install and connect a DrayTek router for ZettaLync internet services.

Updated Nov 17, 20262 min readDrayTekInternetHardwareRouterConnectivity

Introduction

This guide explains how to physically set up your new DrayTek router. Please note that the advanced configuration, security settings, and network management are handled remotely by ZettaLync support, so you do not need to log into the router's admin interface.

Physical Installation Steps

  1. Unpack: Remove the router and power supply from the box.
  2. Connect WAN: Connect the network cable from your ISP modem (or wall handoff) into the port labeled 'WAN' on the back of the router.
  3. Connect LAN: Connect a network cable from one of the 'LAN' ports (numbered 1-4) to your network switch or primary office computer.
  4. Power Up: Plug the power adapter into the router and into a wall outlet. Press the power button if the device does not turn on immediately.
  5. Check Status Lights: Wait approximately 3-5 minutes for the device to boot. The 'ACT' light should be flashing to indicate the device is active, and the 'WAN' light should be solid or blinking to show an internet connection is detected.

Configuration

The router will automatically reach out to our management servers. ZettaLync support handles all technical configuration, firewall rules, and security settings remotely. Site staff are not required to access the router's login page.

Troubleshooting

  • No WAN Light: Check that the cable from your ISP modem is firmly plugged into the 'WAN' port and that your modem is powered on.
  • No Internet: Verify that your network switch is powered on and that the Ethernet cable is securely seated in a 'LAN' port.
  • Status lights are off: Ensure the power cable is firmly connected to both the router and a functioning wall outlet.

If this didn't fix it

If you have completed these steps and are still experiencing connectivity issues, please contact ZettaLync support for assistance. Do not attempt to reset the device unless instructed by a technician.


Drafted by Staff Guide for Kyle Hensley from ab986f277_HOWTOCONFIGDRAYTEKROUTER.xlsx on 2026-11-16. Review before publishing.